3D Touch automatic Leveling Sensor

3D Touch automatic leveling sensor is a device that uses hall effect to achieve leveling. The position of the point can be obtained by touching the point on the hot bed and then compensated by adjusting the Z-axis height during printing,which can be printed even if the platform is uneven.

Specifications
Range Voltage: 5V
Range Current: 15mA
Length of the Line: Short line:200mm/Long Line: 1000mm
Wiring: 3Pin(Green (-,GND),Red(+5V),Orange(Signal Cable))
2Pin(ฺBlack(-,GND),White(Zmin))
Datasheet: Click Here