All Parts required to assemble this kit will be shipped to you.
Preformatted board included. ( not an Etched printed circuit board)
Datasheet & Guide will be sent to you via email in PDF file format after your order confirmation.
Have your 3rd brake light be the attention getter for the other drivers day dreaming and talking on their cell phones. Flashes 4 times before going steady on. Re-sets immediately on applied power to start the flashing cycle again. Uses your existing brake light power so hook-up is simple with 3 wires, 1 ground, 1 from brake light switch or wire, and 1 going to 3rd brake light. Handles up to 8 amps with provided fuse.
Learn the real assembly as it is up to you to layout your parts on the preformatted board.
Schematics and parts are included to complete this project, along with a quick reference guide for parts polarity and the likes. Experiment with layouts; try different ones that may be a better method. Keep parts lengths short, and watch for shorts. Read the guide included for tips.
3rd flashing break lightGreat product, works as described, just what I was looking for, if you ride a motorcycle this is a good asset to have.
There was one "hmm" on the diagram there is a dot close to a line on the crossover line, it was a little confusing as it could be misread as the parts connected on the line, they do not in fact. The diagram is correct by not putting the dot on the line but moving it further away from it would indicate that it is not a connection at the point of intersection that looks like a misprint error.
Other than that the diagram was easily discernible for a rookie like myself.
I bought 2 one for my ride and another for my wife's.
Was fun putting it together and then watching it flash.